3. Carefully remove the old bulb by firmly pulling on the base.
Carefully install the new bulb. Fig. 15
Fig. 15
4. Reinstall the lamp holder and locking ring. Fig. 16
NOTE: This clarifier has a safety feature that only allows the UV
light to turn on if the lamp holder is fully seated into the lamp
housing.
Fig. 16
5. Connect the plug into a properly grounded electrical outlet.
Fig. 17
Fig. 17
6. Wait several seconds for the light to turn on then check the
indicator light to verify if the light is functioning correctly.
Fig. 18
NOTE: This clarifier has a safety feature that only allows the UV
light to turn on if the lamp holder is fully seated into the
lamp housing.
Fig. 18
To Next Page