Error Code Identification:
If there are errors regarding the electronic control system, an error code will appear
automatically. A list of error codes and definitions can be found in Figure 2 at the end of this
manual.
General Settings
After the eBike system is powered on, to access the general settings menu, hold both the UP
and DOWN buttons for 2s. Press the UP or DOWN button to select the desired setting, press
the MODE button to enter the setting configuration page. When accessing the settings menu,
the controller will ask for a password. THE DEFAULT PASSWORD IS 1 2 3 4. This can be
entered by using the UP arrows to change each digit of the combination, followed by the MODE
button to move to the next digit of the combination.
Setting 1: Trip Distance Reset
Clear Trip is used to reset the trip distance. Press the UP or DOWN button to choose YES or
NO to clear the trip distance. The default value is NO. Press the MODE button to confirm the
selection, the display will then show OK and return to the general selection settings interface.
Setting 2: Unit Selection
The default unit for all Tower eBikes is “miles”. To change the units to “kilometers”, press UP or
DOWN until the desired setting is highlighted. Press MODE to store the selection and return to
the general selections interface.
5
To Next Page
Loading...
Need help?
General