Tower Hobbies T17072 - Before first use; SETTING UP; TEST RUN

Before first use
SETTING UP
1. Remove your appliance from the
packaging.
2. Check that there is no damage to the
cord or any visible damage to the body.
3. Check that all listed parts are present.
4. Remove any stickers or labels from the
appliance. DO NOT remove the rating
plate or any warnings.
5. Dispose of the packaging in a
responsible manner.
6. Locate the appliance on a stable,
horizontal, even and heat-resistant
surface in accordance with the
Important safety information section.
7. Wash and dry the accessories and air
fryer, following the instructions in the
Cleaning and care section.
NOTE: DO NOT fill the drawer with oil
or frying fat. This is an oil-free fryer that
works on hot air and uses very little oil or
no oil.
NOTE: The drawer is fully removable from
the unit. Always pull on the handle.
TEST RUN
The appliance should be used for the
first time without any food in it, in order
to remove any manufacturing coating
residues. The appliance may produce
some smoke or odours during this
process.
Allow the appliance to heat up on the
highest temperature setting for approx.
15 minutes, with no food inside.
1. Connect the plug to a mains wall
socket.
. Close the door.
. Set timer to 15 minutes.
. Set the temperature to 200°C
ueosF
WN
. The heating element and fan will
begin to operate and the timer will
begin counting down.
6. When the set time has elapsed, the
appliance will emit an audible signal.
7. Remove the plug from the mains
power socket.
8. Allow the appliance to cool down.
NOTE: The appliance will automatically
enter standby mode after 90 seconds
if no keys are pressed after the control
panel has illuminated.