Need help?Do you have a question about the Toyota 1981 2F and is the answer not in the manual?
General safety and procedural guidelines for performing repairs and maintenance.
Specific safety measures and warnings for vehicles fitted with a catalytic converter.
Glossary of abbreviations and acronyms used throughout the repair manual.
Identifies causes and remedies for engine overheating issues.
Addresses problems related to the engine failing to start or cranking slowly.
Covers symptoms and solutions for engines running roughly or stalling at idle.
Details causes and fixes for engine hesitation and sluggish acceleration.
Explains engine dieseling (run-on) after the ignition is switched off.
Discusses issues related to engine backfires and muffler explosions.
Outlines common reasons for high engine oil consumption.
Provides troubleshooting steps for reduced fuel efficiency.
Explains the function and purpose of various emission control systems.
Visual representation of emission control system components and their interconnections.
Details the PCV system for reducing crankcase blow-by gas emissions.
Describes the EVAP system for controlling fuel vapor emissions.
Explains the SC system for managing ignition timing to reduce emissions.
Covers the EGR system for recirculating exhaust gas to lower combustion temperature.
Details the AI system for injecting air to oxidize exhaust gases.
Explains the function and inspection of the oxidation catalyst.
Describes the HAC system for adjusting air-fuel mixture at high altitudes.
Manages air intake temperature for improved cold-weather driveability.
Adjusts air-fuel mixture during high temperatures at idle.
Opens the choke valve slightly after starting to prevent rich mixtures.
Holds the choke valve open after warm-up to prevent rich mixtures.
Cuts fuel during deceleration to prevent overheating and afterburning.
Heats the intake manifold for better fuel vaporization and driveability.
Procedures for inspecting and adjusting ignition timing.
Steps for inspecting and adjusting the engine's idle speed.
Instructions for adjusting the fast idle speed setting.
Method for checking and verifying idle HC/CO concentrations.
Procedures for adjusting the idle mixture screw and related components.
Technical specifications for the 2F engine model.
Key maintenance intervals and tune-up specifications.
To Next Page
General
