Corolla (U)
201
Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
Light bulbs
Bulb
No.
W Type
Headlights HB2
60/5
5
A
Parking, front side
marker and front
turn signal lights
3157N
A
27/8 C
Rear side marker
lights
194 3.8 C
Rear turn signal
lights
3156 27 C
Stop and tail lights 3157 27/8 C
Back- up lights 921 18 C
License plate lights 194 3.8 C
High mounted
stoplight
— 18 C
Personal light — 10 B
Interior light — 8 D
Trunk light 194 3.8 C
A: HB2 halogen bulbs
B: Single end bulbs
C: Wedge base bulbs
D: Double end bulbs
—Headlights
1. Open the hood.
RIGHT- HAND HEADLIGHT: Remove
the bolts and take out the relay
block.
Put the relay block in the appropriate
place other than on the engine.
NOTICE
Do not place the relay block on the
engine.
To Next Page
Loading...
Need help?
General
