147
26p049b
When the “ACC” mode is enabled, the
initial screen appears and the system be-
gins operating.
After a few seconds, the previous mode
display will appear.
If the electrical power source has been
disconnected from the multi−information
display, the display will be automatically
set to the initial mode.
CAUTION
Do not adjust the display while the
vehicle is moving. Be sure to adjust
the display only when the vehicle is
stopped.
Switch operation
This system operates mainly by the
switches on the screen. To protect the
screen, lightly touch switches on the
screen with your finger. When you touch
a switch on the screen or on the bezel,
a beep sounds.
D If the system does not respond to a
touch of a switch, move your finger
away from the screen and then touch
it again.
D You cannot operate dimmed switches.
D Wipe off fingerprints on the surface of
the display using a glass cleaning
cloth.
Before using
the multi−information display
To Next Page
Loading...
