Fig. 75: Measuring Clearance Between Synchronizer Ring Back & Spline End
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
If the clearance is less than the minimum, replace the synchronizer ring, and apply a small amount
of the fine lapping compound on gear cone.
2. MEASURE NO. 2 SHIFT FORK AND HUB SLEEVE CLEARANCE
Using a feeler gauge, measure the clearance between the hub sleeve and shift fork.
Maximum clearance: 0.69 mm (0.0272 in.)
If the clearance exceeds the maximum, replace the shift fork or hub sleeve.
NOTE: Ensure the fine lapping compound is completely washed off after
rubbing.
2005 Toyota RAV4
2005 TRANSMISSION Manual Transaxle - RAV4
Microsoft
Tuesday, July 21, 2009 9:47:23 AM Page 82 © 2005 Mitchell Repair Information Company, LLC.
To Next Page
Loading...
