376
Remove the cover clips with a Phillips−
head screwdriver and remove the cov-
ers.
Remove and install the cover clip and
cover as shown in the following illustra-
tions.
Removing clip
Installing clip
1: Vertical movement adjusting bolt 1
2: Vertical movement adjusting bolt 2
Before checking the headlight aim:
1. Be sure that the body around the head-
light is not deformed.
2. Park the vehicle on a level spot.
3. The driver gets into the driver’s seat
and puts the vehicle in a state ready-
ing for a driving (with a full tank).
4. Bounce the vehicle several times.
Checking the headlight aim
(with discharge headlight)—
To Next Page
Loading...
