377
1. Turn the vertical movement adjusting
bolt 1 in either direction using a Phil-
lips−head screwdriver. At this time,
keep the turning direction and number
of turns in mind.
2. Turn the vertical movement adjusting
bolt 2 the same number of turns and
in the same direction as step 1 using
a Phillips−head screwdriver.
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
The high mounted stoplight consists of a
number of LEDs. If any of the LEDs burn
out, take your vehicle to your Toyota deal-
er to have the light replaced.
CAUTION
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
—Adjusting the vertical aiming Replacing light bulbs—
To Next Page
Loading...
