Toyota 2010 4RUNNER NAVIGATION SYSTEM Quick Reference Guide

179
2-1. Driving procedures
2
When driving
Turn signal lever
■ Turn signals can be operated when
Vehicles without a smart key system: The engine switch is in the “ON” posi-
tion.
Vehicles with a smart key system: The “ENGINE START STOP” switch is in
IGNITION ON mode.
■ If the indicator flashes faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out.
The turn signal lever can be used to show the following intentions
of the driver:
Right turn
Left turn
Lane change to the right
(push and hold the lever
partway)
The right hand signals will
flash until you release the
lever.
Lane change to the left
(push and hold the lever
partway)
The left hand signals will flash
until you release the lever.
CTH21AS028
Information Provided by:

Toyota 2010 4RUNNER NAVIGATION SYSTEM Specifications

General

Brand	Toyota
Model	2010 4RUNNER NAVIGATION SYSTEM
Category	Automobile
Language	English