427
6-3. Do-it-yourself maintenance
6
Maintenance and care
4RUNNER (U)
■
How to register the ID codes
Select on the multi-information display using the meter con-
trol switches on the steering wheel. (P. 96 )
Select “Vehicle Settings” and then press and hold .
Select “TPWS” and then press .
Select “Change Wheel Set”
then press and hold until
the tire pressure warning
light blinks slowly 3 times.
Then a message will be dis-
played on the multi-information
display.
When registration is being per-
formed, the tire pressure warn-
ing light will blink for
approximately 1 minute then
illuminate and “---” will be dis-
played for the inflation pres-
sure of each tire on the multi-
information display.
Drive straight (with occasional left and right turns) at approxi-
mately 25 mph (40 km/h) or more for approximately 10 to 30 min-
utes.
Registration is complete when the tire pressure warning light turns
off and the inflation pressure of each tire is displayed on the multi-
information display.
Registration may take longer than approximately 1 hour in certain
situations, such as when the vehicle is stopped for a long time at
traffic lights, etc. (P. 4 3 2)
After registering the ID codes, make sure to initialize the tire pres-
sure warning system. (P. 425)
1
2
3
4
5
To Next Page
Loading...
