-15-
SRS Airbags & Seat Belt Pretensioners
Standard Equipment
• Electronic frontal impact sensors (2) are mounted in the engine
compartment n as illustrated.
• Front seat belt pretensioners are mounted near the base of the B-pillars o.
• A frontal dual stage driver airbag p is mounted in the steering wheel hub.
• A frontal dual stage passenger airbag q is integrated into the dashboard
and deploys through the top of the dashboard.
• The SRS computer r, which contains an impact sensor, is mounted on the
floor pan underneath the instrument panel, forward of the shift lever.
• Front door electric side impact sensors (2) are mounted inside the base of
the front doors s.
• Front electronic side impact sensors (2) are mounted near the base of the B-
pillars. t
• Rear electronic side impact sensors (2) are mounted near the base of the C-
pillars. u
• Front seat side airbags v are mounted in the front seatbacks.
• Rear seat side airbags ware mounted in the rear seatbacks.
• Side curtain airbags
are mounted along the outer edge inside the roof
rails.
• Front knee airbags (2)
are mounted on the lower portion of the dash.
Optional Equipment
• The optional pre-collision system contains a radar sensory system and
an electric motor-pyrotechnic pretensioner system. During a pre-
collision event, an electric motor in the pretensioners retracts the front
seatbelts. When conditions stabilize the electric motor will reverse
itself. When the airbags deploy, or as necessary, the pyrotechnic
pretensioners function normally.
WARNING:
The SRS may remain powered for up to 90 seconds after the vehicle is
shut off or disabled. To prevent serious injury or death from
unintentional SRS deployment, avoid breaching the SRS components.
Electronic Impact Sensors and Side Airbags
Standard Frontal Airbags, Seat Belt Pretensioners, Knee Airbags,
Side Curtain Airbags
q
t
n
u
o
o
Side Curtain Airbag Inflators
t
v
s
r
v
w
w
p
r
s
u
To Next Page
Loading...
