32
TOYOTA SAFETY SENSE
™
CHANGING PCS ALERT TIMING
Monocular camera sensor
Millimeter
wave radar
As part of the Pre-Collision System, this function is also designed to first provide an
alert and then automatic braking if needed.
Refer to the Toyota Owner’s Manual for additional limitations and information.
Under certain conditions, the PCS system included with the TSS-P package may
also help to detect a pedestrian in front of your vehicle using the forward-facing
camera and front grille-mounted radar. The forward-facing camera of PCS detects a
potential pedestrian based on size, profile, and motion of the detected pedestrian.
However, a pedestrian may not be detected depending on the conditions, including
the surrounding brightness and the motion, posture, size, and angle of the potential
detected pedestrian, preventing the system from operating or engaging.
PCS PEDESTRIAN DETECTION
Far
Middle
(default)
Near
(1) Press “ ” switches and select “ ” from the Multi-Information Display (MID).
(2) Press “
” or “ ” switches and select “ (PCS)” and then press and “ .”
The setting screen is displayed.
(3) Press “
” or “ ” switches and select “Warning sensitivity” and then press and
hold “
” to select the desired setting. Each time it is pressed, the response to
the PCS alert timing changes as shown above.
(4) You can press “
” to go back to the menu.
Note: PCS is enabled each time the vehicle is turned on. The system can be
disabled/enabled and the alert timing of the system can be changed. (Alert
timing only, brake operation remains the same).
To Next Page
Loading...
