Toyota Corolla Cross 2024 - Page 354

354
6-3. Do-it-yourself maintenance
■ Checking the oil type and
preparing the item needed
Make sure to check the oil type
and prepare the items needed
before adding oil.
 Engine oil selection
P.440
 Oil quantity (Low level mark
 Refill upper limit mark)
1.6 qt. (1.5 L, 1.3 Imp. qt.)
 Item
Clean funnel
■ Adding engine oil
If the oil level is below or near
the low level mark, add engine
oil of the same type as that
already in the engine.
1 Remove the oil filler cap by
turning it counterclockwise.
2 Add engine oil slowly, check-
ing the dipstick.
Make sure that the oil level does
not exceed the refill upper limit
mark and is between the low level
mark and refill upper limit mark.
Low level mark
Refill upper limit mark
The shape of the dipstick may differ
depending on the type of vehicle or
engine.
3 Install the oil filler cap by
turning it clockwise.
■ After changing the engine oil
The engine oil maintenance data
should be reset. Perform the follow-
ing procedures:
Use the meter control switches to
reset. (P.84, 91)
 4.2-inch display
1 Park the vehicle in a safe place
and then start the engine. The oil
maintenance cannot be reset
while the vehicle is moving.
2 Select of the multi-informa-
tion display and then press OK.
3 Press or to select “Vehi-
cle Settings” and then press and
hold .
4 Press or to select “Oil
Maintenance” and then press
.
5 Press or to select “Yes”
and then press .
Adding engine oil