440
8-1. Specifications
■ Oil capacity (Drain and refill
[Reference
*
])
*
: The engine oil capacity is a refer-
ence quantity to be used when
changing the engine oil. When
actually adding the engine oil,
make sure that the oil level is
between the low level mark and
refill upper limit mark (P.354).
Warm up and turn off the engine,
wait about 5 minutes, and check
the oil level on the dipstick.
■ Engine oil selection
“Toyota Genuine Motor Oil” is
used in your Toyota vehicle. Use
Toyota approved “Toyota Genu-
ine Motor Oil” or equivalent to
satisfy the following grade and
viscosity.
Oil grade: JASO GLV-1
Recommended viscosity: SAE
0W-8
Outside temperature
SAE 0W-8 is the best choice for
good fuel economy and good
starting in cold weather.
If SAE 0W-8 is not available,
SAE 0W-16 oil may be used.
However, it must be replaced
with SAE 0W-8 at the next oil
change.
Oil viscosity (0W-8 is explained
here as an example):
• The 0W in 0W-8 indicates the
characteristic of the oil which
allows cold startability. Oils
with a lower value before the
W allow for easier starting of
the engine in cold weather.
• The 8 in 0W-8 indicates the
Fuel
Fuel type Unleaded gasoline only
Octane Rating
87 (Research Octane Number 91) or
higher
Fuel tank capacity
(Reference)
2WD models
12.4 gal. (47.0 L, 10.3 Imp. gal.)
AWD models
13.2 gal. (50.0 L, 11.0 Imp. gal.)
Lubrication system
With filter
4.4 qt. (4.2 L, 3.7 Imp.
qt.)
Without
filter
4.1 qt. (3.9 L, 3.4 Imp.
qt.)
To Next Page
Loading...
