41
3-1. CONTROLS
3
CONTROLS
depressions or in tight curves.
• When the camera field of view
is covered, for instance by a
fogged up windshield or
labels.
• When the camera lens is dirty
or damaged.
• When driving toward bright
lights or strong reflections,
e.g., because of a setting sun.
• When it is dark outside.
• Camera behind the wind-
shield: if the camera has over-
heated and been temporarily
switched off due to exces-
sively high temperatures.
• Camera behind the wind-
shield: during calibration of
the camera immediately after
vehicle delivery.
If applicable, a Check Control
message is displayed if the sys-
tem fails.
The radar sensor is located in
the front bumper.
*
: if equipped
The radar sensors are located in
the bumper.
The radar sensors may not be
fully functional or may not be
available in the following situa-
tions:
• If sensors are dirty, such as
due to icing.
• If sensors are covered, such
as by labels, films or a num-
ber plate baseplate.
• If the sensor is not aligned
correctly, for instance due to
parking damage.
• If the radiation range of the
sensors is covered, e.g., by
protruding cargo.
• If the field of view of the sen-
sors is covered, e.g., by
garage walls, hedges or snow
hills.
• After improperly performed
work on the vehicle paint in
the area of the sensors.
• On steep hilltops or in sharp
Radar sensors
Front radar sensor
Radar sensors, side, rear*
System limits of the radar
sensors
To Next Page
Loading...
