Toyota MR2 Repair Manual

FOREWORD
This repair manual has been prepared to provide essential information on
body panel repair methods (including cutting and welding operations, but
excluding painting) for the TOYOTA MR2.
Applicable models: ZZW30 series
This manual consists of body repair methods, exploded diagrams and il-
lustrations of the body components and other information relating to body
panel replacement such as handling precautions, etc. However, it should
be noted that the front fenders of the TOYOTA model is bolted on and
require no welding.
When repairing, don’t cut and join areas that are not shown in this manual.
Only work on the specified contents to maintain body strength.
Body construction will sometimes differ depending on specifications and
country of destination. Therefore, please keep in mind that the information
contained herein is based on vehicles for general destinations.
For the repair procedures and specifications other than collision-damaged
body components of the TOYOTA MR2 refer to the repair manuals.
If you require the above manuals, please contact your TOYOTA Dealer.
All information contained in this manual is the most up-to-date at the time
of publication. However, specifications and procedures are subject to
change without prior notice.

Toyota MR2 Specifications

Mechanical/Performance

engine capacity	1.8-liter
horsepower	138 hp @ 6, 400 rpm
torque	125 lb.-ft. @ 4, 400 rpm
bore x stroke	79.0 mm x 91.5 mm
compression ratio	10.0:1

Exterior Dimensions

overall height	48.8 in.
overall width	66.7 in.
overall length	153.0 in.
wheelbase	96.5 in.
ground clearance	4.9 in.

Interior Dimensions

head room	37.3 in.
shoulder room	51.0 in.
hip room	49.8 in.
leg room	42.2 in.
seating capacity	2

Weights and Capacities

curb weight (manual)	2, 195 lbs.
curb weight (sequential manual)	2, 215 lbs.
passenger volume	48.0 cu. ft.
cargo volume	1.5 cu. ft.
fuel tank capacity	12.7 gal.