188
Replacing light bulbs
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the motor switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
Light bulbs
Bulb
No.
W Type
Headlight
Inner
Outer
HB3
HB4
60
51
B
A
Parking/front turn signal
lights
1157NA 27/8 C
Front side marker lights 217 5 D
Rear side marker lights 194 3.8 D
Rear turn signal lights 7740 21 D
Stop/tail lights 7743 21/5 D
Back−up lights 7740 21 D
License plate light 217 5 D
High mounted
stoplight
921 18 D
Interior light 8 E
Personal lights 8 C
A: HB4 halogen bulbs
B: HB3 halogen bulbs
C: Single end bulbs
D: Wedge base bulbs
E: Double end bulbs
Headlights
1. Open the hood. Unplug the connec-
tor while depressing the lock re-
lease.
If the connector is tight, wiggle it.
To Next Page
Loading...
