47
CHANGING PRE-COLLISION ALERT TIMING
DISABLING PRE-COLLISION SYSTEM (PCS)
Far
Middle
(default)
Near
(1) Press “ ” switches and select “ ” from the Multi-Information Display (MID).
(2) Press “
” switches and select “ PCS” and then press and hold “ .” The
setting screen is displayed.
(3) Press “
” switches and select “Sensitivity” and then press “ ” to change
the desired setting. Each time it is pressed, the PCS alert timing changes as
shown above.
(4) Press “
” to go back to the menu.
Note: PCS is enabled each time the vehicle is turned on. The system can be
disabled/enabled and the alert timing of the system can be changed. (Alert
timing only, brake operation remains the same.)
(1) Press “
” switches and select “ ” from the Multi-Information Display (MID).
(2) Press “
” switches and select “ PCS” and then press “ ” to turn PCS
on or off.
Note: The system is enabled each time the vehicle is turned on.
Refer to the Toyota Owner’s Manual for additional information on PCS w/PD
operation, settings adjustments, limitations, and precautions before attempting to
use it.
OVERVIEWFEATURES & OPERATIONSTOYOTA SAFETY SENSESAFETY & EMERGENCY FEATURES
To Next Page
Loading...
