367
8-2. Steps to take in an emergency
8
When trouble arises
Inflate the tire until the specified
air pressure is reached.
The sealant will be injected
and the pressure will spike to
44 psi (300 kPa, 3.1 kgf/cm
2
or bar) or 58 psi (400 kPa,
4.1 kgf/cm
2
or bar), and then
gradually decrease.
The air pressure gauge will
display the actual tire infla-
tion pressure about 1 minute
(15 minutes at low tempera-
ture) after the switch is
turned on.
Inject to specified air pres-
sure.
• Turn the compressor switch
off and then check the tire
inflation pressure. Being
careful not to over inflate,
check and repeat the infla-
tion procedure until the
specified tire inflation pres-
sure is reached.
• If the tire inflation pressure
is still lower than the speci-
fied point after inflation for
10 minutes (40 minutes at
low temperature) with the
switch on, the tire is too
damaged to be repaired.
Turn the compressor switch
off and contact your Scion
dealer.
• If the tire inflation pressure
exceeds the specified air
pressure, let out some air to
adjust the tire inflation pres-
sure. (P. 371, 400)
13
1
2
3
To Next Page
Loading...
