47
2. Bluetooth
®
SETTINGS
2
BASIC FUNCTION
1 Display the “Bluetooth* Setup” screen.
(P.46)
2 Select “Add”.
When another Bluetooth
®
device is con-
nected
To disconnect the Bluetooth
®
device,
select “Yes”.
When 5 Bluetooth
®
devices have al-
ready been registered
A registered device needs to be replaced.
Select “Yes”, and select the device to be
replaced.
3 When this screen is displayed, search
for the device name displayed on this
screen on the screen of your
Bluetooth
®
device.
For details about operating the Bluetooth
®
device, see the manual that comes with it.
To cancel the registration, select “Can-
cel”.
4 Register the Bluetooth
®
device using
your Bluetooth
®
device.
A PIN-code is not required for SSP
(Secure Simple Pairing) compatible
Bluetooth
®
devices. Depending on the
type of Bluetooth
®
device being con-
nected, a message confirming registra-
tion may be displayed on the Bluetooth
®
device’s screen. Respond and operate the
Bluetooth
®
device according to the confir-
mation message.
5 Check that the following screen is dis-
played when registration is complete.
The system waits for connection requests
coming from the registered device.
At this stage, the Bluetooth
®
functions are
not yet available.
6 Select “OK” when the connection sta-
tus changes from “Connecting...” to
“Connected”.
If an error message is displayed, follow
the guidance on the screen to try again.
*: Bluetooth is a registered trademark of
Bluetooth SIG, Inc.
REGISTERING A Bluetooth
®
DEVICE
Up to 5 Bluetooth
®
devices can be reg-
istered.
Bluetooth
®
compatible phones (HFP)
and audio players (AVP) can be regis-
tered simultaneously.
This operation cannot be performed
while driving.
To Next Page
Loading...
Need help?
General
