To Next PageTo Next PageWhat to do if my Toyotomi Water Heater operation lamp blinks?
If the operation lamp on your Toyotomi Water Heater is blinking, the short-circuit terminal of timer connection “L” on the circuit board might be disconnected. Connect the short-circuit terminal correctly. Alternatively, the unit may be in a stand-by state due to the automatic operation of the timer, which is normal.
What to do if my Toyotomi Water Heater is extinguished after ignition?
If your Toyotomi Water Heater extinguishes after ignition, it could be due to several reasons. The flame sensor might be dirty and needs cleaning, or it could be malfunctioning and needs replacement. There might be a fuel restriction, in which case you should remove any air. Also, check the flame sensor and clean it if it is dirty.
How to fix a Toyotomi Water Heater when the blower motor operates but there is no ignition?
If the blower motor in your Toyotomi Water Heater is running but there's no ignition, check the fuel level; refuel if necessary. Also, there might be an air pocket in the fuel line that needs to be removed, or the fuel strainer might be clogged and needs cleaning. If there is abnormal lowering of electrical voltage, contact electricians.
What to do if my Toyotomi Water Heater power lamp fails to turn on?
If the power lamp on your Toyotomi Water Heater doesn't turn on, the power supply cord might be disconnected. Make sure to connect the power supply cord.
Why is my Toyotomi Water Heater making noise from the fuel pump?
If your Toyotomi Water Heater's fuel pump is making noise, it could be due to an air lock in the fuel line. Try removing the air to resolve the issue.
Why is my Toyotomi Water Heater accumulating soot?
Soot accumulation in your Toyotomi Water Heater can be caused by improper installation of the flue pipe, so re-install it properly. Also, a fuel nozzle failure can cause soot accumulation, so replace it.
Why is my Toyotomi Water Heater combustion noisy?
Noisy combustion in your Toyotomi Water Heater can be caused by a fuel nozzle failure, so replace it. Also, if the flue pipe is improperly installed, re-install it properly.
What to do if hot water temp is too low in Toyotomi Water Heater?
If the hot water temperature from your Toyotomi Water Heater is too low and the hot water supply is beyond capacity, close the hot water faucet partially.
What to do if there is water leakage from my Toyotomi Water Heater?
If there's water leakage from your Toyotomi Water Heater, it could be due to a gasket malfunction. In this case, replace the gasket.
General| Brand | Toyotomi |
|---|---|
| Model | Oil Miser OM-128HH |
| Category | Water Heater |
| Language | English |
Provides additional safety advice and usage guidelines beyond the main safety tips.
Details the unit's built-in safety devices and their functions.
Provides physical dimensions and connection port details of the water heater.
Illustrates the electrical connections for the water heater's components.
Checklist of essential checks before turning on the water heater.
Instructions on how to set and change the water temperature output.
Steps to safely shut down the water heater.
Methods to protect the unit from freezing damage.
Guidance for storing the unit when unused for extended periods.
Regular checks and maintenance tasks for optimal performance and safety.
