Quick Installation Guide
AC1200 Wireless Dual Band Router
If your Internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the router’s Internet port, then follow steps 4 and 5 to
complete the hardware connection.
Verify that the hardware
connection is correct by
checking these LEDs.
5
2.4G
On
5G
On
On
Internet
Power
On
Note: If the 2.4G LED and 5G LED
are o, please press the Wi-Fi button
on the rear panel for 2 seconds, then
check the LEDs again in a few seconds.
Connect the Hardware
Power adapter
Power adapter
Turn on the router.
4
Internet
Router
Turn on the modem, and
then wait about 2 minutes
for it to restart.
3
Connect the modem to the
Internet port on your router
with an Ethernet cable.
Turn o the modem,
and remove the backup
battery if it has one.
1
2
To Next Page
