English
1
Note:
1. The product model shown in this QIG for Wireless Dual Band Gigabit
Router is “Archer C8”,as an example.
2. Information for technical support can be found in the last page.
Connecting the Hardware
If your Internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the Archer C8’s Internet port.
USB 2.0 PowerInternetRESET/WPS On/Off1234Ethernet
Modem
INTERNET
1. Turn off the modem, and remove the backup battery if it has one.
2. Connect the modem to the Internet port on your Archer C8 with an
Ethernet cable.
3. Turn on the modem, and then wait 2 minutes for it to restart.
4. Turn on the Archer C8.
5. Verify that the hardware connection is correct by checking these LEDs.
Power: On
2.4/5G: On
Internet: On
Note: If the 2.4/5G LED is not on, please verify that the wireless switch
on the side panel of the Archer C8 is on.
To Next Page
Loading...
