English
5
FAQ (Frequently Asked Questions)
Q1. What can I do if the login window does not appear?
A1. If the computer is set to a static or fixed IP address, change the setting
to obtain an IP address automatically.
A2. Verify that ‘http://tplinklogin.net’ is correctly entered in the web browser.
Alternatively, enter ‘http://192.168.0.1’ in the web browser and press ‘Enter’.
A3. Use another web browser and try again.
A4. Reboot your Archer C8 and try again.
A5. Disable then re-enable the network adapter being used.
Q2. What can I do if I cannot access the Internet?
A1. Check if the Internet is working properly by connecting a computer
directly to the modem through Ethernet. If it is not, contact your Internet
Service Provider.
A2. Open a web browser, enter ‘http://tplinklogin.net’ and try to set up
again.
A3. Reboot your Archer C8 and try again.
A4. For cable modem users, reboot the modem first. If the problem still
exists, log in to the Web Management page of the Archer C8, and go to
‘Advanced’ -> ‘Network’ -> ‘MAC Clone’ , click on ‘Clone MAC Address’ then
click on ‘Save’.
Q3. How do I restore the Archer C8 to its factory default settings?
A1. With the Archer C8 in the ‘Power On’ mode, press and hold down the
‘Reset/WPS’ button on the rear panel of the Archer C8 for approximately 8
seconds.
A2. Log in to the Web Management page of the Archer C8, and go to
‘Advanced’ -> ‘System tools’->’Factory Defaults’, click ‘Restore’, then wait until
the loading progress bar finishes.
Q4. What can I do if I forget my password?
Web Management page password:
A. Restore the Archer C8 to its factory default settings and then use the
default User Name ’admin’ and Password ’admin’ to log in.
To Next Page
Loading...
