TP-Link Archer D20 Quick Installation Guide

Verify that the hardware connection
is correct by checking these LEDs.
4
Note:
1. The ADSL LED takes about 1 to 2 minutes to stabilize.
2. If the 2.4GHz LED and 5GHz LED are off, please press the Wi-Fi
button on the rear panel for 2 seconds, then check the LEDs again in a
few seconds.
Power On
On5GHzOn2.4GHzOnADSL
Quick Installation Guide
7106505550 REV1.0.2
Connecting the Hardware
ADSL Splitter
Phone Jack
Connect to the phone (Optional)
2 Connect the modem router to the
ADSL splitter.
3 Turn on the modem router.
Power Adapter
If you don’t need the phone service, just directly connect the modem router to
the phone jack with a phone cable, then follow steps 3 and 4 to complete the
hardware connection.
1 Connect the ADSL splitter
to the phone jack.
Modem Router
AC750 Wireless Dual Band
ADSL2+ Modem Router

TP-Link Archer D20 Specifications

General

VPN support	PPTP, L2TP, IPSec Passthrough
Ethernet LAN	Yes
Cabling technology	10/100Base-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3ab, IEEE 802.3u
VPN tunnels quantity	10
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Wi-Fi band	Dual-band (2.4 GHz / 5 GHz)
RJ-11 ports quantity	1
Ethernet LAN (RJ-45) ports	4
USB version	1.1
Rack mounting	No
Frequency band	2.4 & 5 GHz
Data link protocols	IPv4, IPv6
Supported network protocols	ATM Forum UNI3.1/4.0, PPP over ATM (RFC 2364), PPP over Ethernet (RFC2516), IPoA (RFC1577/2225), MER\\IPoE (RFC 1483 Routed), Bridge (RFC1483 Bridge), PVC
Transmit power	0 dBmW
Antennas quantity	2
Security algorithms	128-bit WEP, 64-bit WEP, WPA, WPA-PSK, WPA2, WPA2-PSK
Product color	Black
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %
Certification	CE, FCC, RCM, RoHS
Cables included	LAN (RJ-45), Phone (RJ-11)

Weight and Dimensions

Depth	141 mm
Width	202 mm
Height	33.7 mm
Weight	- g