4 Verify that the hardware connection
is correct by checking these LEDs.
Notes:
1. The ADSL LED takes about 1 to 2 minutes to stabilize.
2. If the 2.4GHz LED and 5GHz LED are off, please press
the Wi-Fi button on the rear panel for 2 seconds, then check
the LEDs again in a few seconds.
Power On On5GHzOn2.4GHzOnADSL
AC1200 Wireless Dual Band ADSL2+ Modem Router
Quick Installation Guide
Connecting the Hardware
If you don’t need the phone service, just directly connect the
modem router to the phone jack with a phone cable, then follow
steps 3 and 4 to complete the hardware connection.
ADSL Splitter
Phone Jack
Power Adapter
Modem Router
2 Connect the modem router
to the ADSL splitter.
3 Turn on the modem router.1 Connect the ADSL splitter
to the phone jack.
To Next Page
