26
Chapter 6
Network Security
1 ) Select Below wireless access only from the devices in the
below list or Allow wireless access only from the devices
in the below list and click Save.
2 ) Click Add.
3 ) Click View Existing Device to display the existing online
device. Then select the device(s) in the table. The
MAC Address of the selected devices will be added
automatically.
4 ) Enter the Description of the device.
5 ) Select the checkbox to enable this entry, and click OK.
Now MAC Filtering is implemented to protect your wireless
network.
6. 2. Access Control
Access Control is used to block or allow specific client devices to access your network
(via wired or wireless) based on a list of blocked devices (Blacklist) or a list of allowed
devices (Whitelist).
Block or allow specific client devices to access my network (via
wired or wireless).
1. Visit http://tplinkmodem.net, and log in with the password
you set for the router.
2. Go to Advanced > Security > Access Control and enable
Access Control.
Done!
I want to:
How can I
do that?
To Next Page
Loading...