Tri-Band Wi-Fi 6 Router
Quick Installation Guide
Images may dier from actual product. ©2022 TP-Link 7106509665 REV1.0.0
If your internet connection is through an Ethernet cable directly from the wall instead of through a DSL / Cable / Satellite modem, connect
the Ethernet cable to the router’s 2.5 Gbps WAN/LAN port and follow step 3 and 4 to complete the hardware connection.
Modem
Unplug the power
Connect the Hardware
1
Internet
Connect the power adapter to the router
and turn on the router.
3
Power on the modem, and then wait
about 2 minutes for it to restart.
2
Verify the LED is solid on (red or blue)
before moving on.
4
Connect the powered-off modem to the 2.5 Gbps
WAN/LAN port with an Ethernet cable.
Note: If you want to use the 1 Gbps WAN/LAN port as the WAN port
instead, please refer to Q1 of Need Help in this guide.
1
• Unplug the power to turn o your modem, if any, and remove the backup battery if it has one.
• Refer to Q5 of Need Help to place the router for optimal Wi-Fi performance.
Set up with videos:
Scan QR code or visit https://www.tp-link.com/support/setup-video/#wi--routers
To Next Page
Need help?
General
