Installation Guide
Hardware Connection
13
Hardware Overview
1
Hardware Overview
2
© 2022 TP-Link 7106509940 REV1.0.1
Package Contents
1
Note: The image may dier from the actual product.
Front Panel
Connect via ber network
Connect via Ethernet
Back Panel
Fiber-Optic Cable
Optical Module
Connect to RJ45 WAN Port
Connect to SFP WAN Slot
Router
Installation Guide
Rubber Feet
Power Adapter
Omada Gigabit VPN Router
with PoE+ Ports and Controller Ability
Modem
Internet
Internet
Green On: The port is supplying power normally.
Green Flashing: Overload or short circuit is detected.
O: Not providing PoE power on the port.
PoE
(Port 5-12)
Speed
(Port 5-12)
Green On: Running at 1000 Mbps, but no activity.
Green Flashing: Running at 1000 Mbps and transmitting or receiving data.
Amber On: Running at 100/10 Mbps, but no activity.
Amber Flashing: Running at 100/10 Mbps and transmitting or receiving data.
O: No device is linked to the corresponding port.
Green On: Running at 1000 Mbps, but no activity.
Green Flashing: Running at 1000 Mbps and transmitting or receiving data.
Amber On: Running at 100/10 Mbps, but no activity.
Amber Flashing: Runni
ng at 100/10 Mbps and transmitting or receiving data.
O: No device is linked to the corresponding port.
Link/Act
(Port 3-4)
Green On: Connecting to a device but no activity.
O: No device connected to the corresponding port.
Flashing: Transmitting or receiving data.
Link/Act
(SFP WAN/LAN)
On: The remaining PoE power is ≤ 7 W.
Flashing: The remaining PoE power keeps ≤ 7 W after this LED is on for 2 minutes.
O: The remaining PoE power is > 7 W.
PoE Max
On: The device is bound to a TP-Link ID.
Slow Flashing: The device is connected to cloud but not bound to a TP-Link ID.
Quick Flashing: The device is being reset to its factory default settings.
O: The device is disconnected from cloud.
CLOUD
Flashing: System is running normally.
On/O: System is running abnormally.
SYS
On: Power is on.
O: Power is o.
PWR
LED Indication
Kensington
Security Slot
RESET
Power SocketGrounding Terminal
SFP SlotLED 1 Gbps RJ45 Port
PoE LEDSpeed LED
Kensington Security Slot: Secure the lock (not provided) into the security slot
to prevent the device from being stolen.
RESET: Press and hold the button for 5 seconds, the SYS LED will ash quickly,
indicating the device is being reset to its factory default settings.
Grounding Terminal: The router comes with lightning protection mechanism.
Power Socket: Connect to the power outlet via the provided power adapter.
To Next Page
Need help?
General
