5
Chapter 1
Get to Know About Your Router
Some Common LEDs Explanation
LED Status Indication
(Power)
On The system has started up successfully.
Flashing
The system is starting up or the firmware is being upgraded. Do
not disconnect or power off your router.
Off Power is off.
(Internet)
On Internet service is available.
Off The router’s WAN port is unplugged.
(2.4GHz Wireless)
On The 2.4GHz wireless band is enabled.
Flashing The router is transmitting or receiving data via 2.4GHz band.
Off The 2.4GHz wireless band is disabled.
(5GHz Wireless)
On The 5GHz wireless band is enabled.
Flashing The router is transmitting or receiving data via 5GHz band.
Off The 5GHz wireless band is disabled.
(WPS)
On/Off
Turns on when a WPS synchronization is established and
automatically turns off about 5 minutes later.
Flashing
A wireless device is trying to connect to the network via WPS.
This process may take up to 2 minutes.
(WAN)
On A device is connected to the WAN port.
Flashing The WAN port is sending or receiving data.
Off No device is connected to the WAN port.
(LAN)
On A device is connected to the LAN port.
Flashing The LAN port is sending or receiving data.
Off No device is connected to the LAN port.
(PHONE)
On The SIP account is registered successfully.
Flashing
Slowly
The phone is on-hook and there are voice messages.
Flashing
Quickly
The phone is ringing.
Off No SIP account is registered.
(USB)
On The USB device is identified and ready to use.
Flashing A new USB device is being identified, or data is being transferred.
Off No USB device is plugged in to the USB port.
To Next Page
Loading...
