TP-Link M7000

d. Note down the default SSID and Wireless
Password. Then replace the cover.
a. Remove the back cover.
b. Install your SIM card.
SSID: TP-Link_XXXX
Wireless Password: XXXXXXXX
c. Install the provided battery.
SSID: TP-Link_XXXX
Wireless Password: XXXXXXXX
1
2
1. Install the SIM Card and Battery
· If you cannot access the internet, refer to FAQ > Q1.
·
By default, Power Saving is enabled and the Mobile Wi-Fi will turn o Wi-Fi when no wireless devices are connected to it for 10 minutes.
To resume the Wi-Fi connection, press the Power button.
!
2. Connect to the Internet
©2020 TP-Link 7106508955 REV3.0.0
!
The LEDs will turn o automatically after idling for 30 seconds. To check the LED
status, press the Power button to turn them on again.
LED Indicators
Solid Green
Blinking Red
Blinking Green
O
On/O
On/O
Status Explanation
Wi-Fi is enabled or disabled.
Internet service is available or unavailable.
LED
(Battery)
(Wi-Fi)
(Internet)
* Images are for demonstration only.
b. Connect your wireless device to the Mobile Wi-Fi using the
SSID and the Wireless Password you have noted down.
a. Press and hold the Power button
to power on the Mobile Wi-Fi.
SSID:
TP-Link_XXXX
Wireless Password:
XXXXXXXX
Wi-Fi
Wi-Fi
TP-Link_XXXX
CHOOSE A NETWORK...
Other...
< Settings
Enjoy the internet!
Quick Installation Guide
Mobile Wi-Fi
SSID:
TP-Link_XXXX
Wireless Password:
XXXXXXXX
SSID: TP-Link_XXXX
Wireless Password: XXXXXXXX
SSID:
TP-Link_XXXX
Wireless Password:
XXXXXXXX
+ +
SIM card requirement:
!
+ +
Micro SIM card +
Provided Micro SIM card adapter + Provided sticker
Standard
SIM card
Nano SIM card +
Provided Nano SIM card adapter + Provided sticker
Mobile Wi-Fi has enough power or is fully charged.
The battery level is lower than 10%.
Mobile Wi-Fi is charging.
Power is o.