TP-Link Nano

How to connect TP-Link Nano Router to WiFi-Router
1. Turn on TP-Link Nano Router by connect USB with Adapter or connect with Notebook
2.
Connect TP-Link Nano Router WiFi
3. After connected,
Fix IP Address at Notebook is in a same network with TP-Link Nano Router
- Default IP Address: 192.168.0.254
- Fix IP Address: 192.168.0.xxx (any IP Address)
- Subnet Mask: 255.255.255.0
- Default Gateway: 192.168.0.1

TP-Link Nano Specifications

General

Model	TL-WR802N
Wireless Standards	IEEE 802.11n, IEEE 802.11g, IEEE 802.11b
Power Supply	5V/1A
Wireless Speed	300Mbps
Frequency	2.4GHz
Wireless Security	64/128-bit WEP, WPA-PSK/WPA2-PSK, WPA/WPA2
Button	Reset Button
Operation Modes	Router mode, Range Extender mode, Access Point mode, Client mode, WISP mode
Antenna	Internal Antenna
Ports	1 x 10/100Mbps WAN/LAN port

Summary

TP-Link Nano Router Connectivity and Initial Access

Connecting TP-Link Nano Router to WiFi

Connect the TP-Link Nano Router via USB or notebook and connect to its WiFi.

Configuring Notebook IP Address

Manually set the notebook's IP address to match the router's network.

Accessing Router Web Interface

Open a browser and navigate to the router's default IP address to log in.

TP-Link Nano Router Repeater Mode Setup

Initiating Quick Setup and Selecting Mode

Start the Quick Setup wizard and choose the Repeater Mode for operation.

Scanning and Connecting to Target Wi-Fi

Survey available Wi-Fi networks and select the desired network to connect to.

Entering Wi-Fi Security Credentials

Input the SSID, password, and security options for the selected Wi-Fi network.

Applying Settings and Finalizing Connection

Rebooting Router for Configuration

Reboot the router to save and apply the new configuration settings.

Updating Notebook IP Address

Adjust the notebook's IP address to match the router's new configuration.

Verification and Reset Procedure

Accessing Router Post-Configuration

Attempt to access the router using its new IP address to verify connectivity.

Performing a Factory Reset

Reset the TP-Link Nano Router to its default factory settings using the reset button.