NC230 HD Day/Night Wi-Fi Cloud Camera
NC25
0 HD Day/Night Cloud Camera, 300Mbps Wi-Fi
5
ETHERNET Port: The ETHERNET port is used to connect the camera to a network via RJ45
cable.
Power Jack: The power jack is where you connect the AC adapter to the camera.
WPS/RESET Button: This button is used for both WPS and RESET function. To use the WPS
function, press it for 1 second. To use the RESET function, press and hold for more than 5
seconds.
Used as WPS button:
If your wireless router supports WPS (Wi-Fi Protected Setup), you can connect the
camera to your Wi-Fi network using WPS. Press the WPS or QSS button on your router.
Within 2 minutes, press the WPS/RESET button on the camera for about 2 seconds,
then the LED above this button will start flashing quickly. When this LED becomes solid
on, the WPS is successful.
Used as RESET button:
With the camera powered on, press and hold the WPS/RESET button (more than 5
seconds) until the System LED turns off. Then release the button and wait the camera to
reset to its factory default settings.
Heat Emission Holes: These holes are used for heat dissipation.
To Next Page
Loading...
