This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, uses and can radiate 
radio frequency energy and, if not installed and used in accordance with the 
instructions,  may  cause  harmful  interference  to  radio  communications. 
However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or 
more of the following measures: 
●  Reorient or relocate the receiving antenna. 
●  Increase the separation between the equipment and receiver. 
●  Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.   
●  Consult the dealer or an experienced radio/ TV technician for help. 
This device complies with part 15 of the FCC Rules. Operation is subject to 
the following two conditions: 
  This device may not cause harmful interference. 
  This  device  must  accept  any  interference  received,  including 
interference that may cause undesired operation. 
Any  changes  or  modifications  not  expressly  approved  by  the  party 
responsible for compliance could void the user’s authority to operate the 
equipment. 
Note: The manufacturer is not responsible for any radio or tv interference 
caused by unauthorized modifications to this equipment. Such modifications 
could void the user’s authority to operate the equipment. 
This equipment complies with FCC RF radiation exposure limits set forth for 
an uncontrolled environment. This device and its antenna must not be co-
located or operating in conjunction with any other antenna or transmitter. 
“To comply with FCC RF exposure compliance requirements, this grant is 
applicable  to  only  Mobile  Configurations.  The  antennas  used  for  this 
transmitter must be installed to provide a separation distance of at least 20 
cm from all persons and must not be co-located or operating in conjunction 
with any other antenna or transmitter.” 
   
This is a class B product. In a domestic environment, this product may cause 
radio interference, in which case the user may be required to take adequate 
measures. 
National Restrictions 
This device is intended for home and office use in all EU countries (and 
other countries following the EU directive 1999/5/EC) without any limitation 
except for the countries mentioned below: