©2020 TP-Link
7106508585 REV1.1.0
Plug the extender into a power outlet next to your router. Wait until its
POWER LED turns solid on.
Power On
Set Up
2
Method 3: Via the WPS Button
1. Press the WPS button on your router.
The WPS button might
look like one of these:
3. Launch the Tether app, and select your extender.
Create a password to log in.
Quick Installation Guide
Range Extender
RE455
2. Launch a web browser, and enter
http://tplinkrepeater.net or http://192.168.0.254
in the address bar. Create a password to log in.
Note: If the login window does not appear, refer to FAQ > Q1.
http://tplinkrepeater.net
Start
Conrm Password
Create Password
Low Middle High
My Devices
Local Device
RE455
XX-XX-XX-X X-XX-X X
1
Next to
Solid On
Enjoy!
Connect your devices to the extender wirelessly or via an Ethernet cable, then
enjoy the internet.
Tip: You can also set up the extender in Access Point mode to transform your existing wired network
to a wireless one. For details, refer to the user guide at https://www.tp-link.com/support.
Solid On
4. Follow app instructions to complete the setup.
The LED should turn solid on, indicating
successful connection to your router.
Note: If the LED does not turn solid on, refer to FAQ > Q2.
Solid On
3. Follow web instructions to complete the setup.
The LED should turn solid on, indicating
successful connection to your router.
Note: If the LED does not turn solid on, refer to FAQ > Q2.
Relocate
3
1. Plug in the extender about halfway between your router and the Wi-Fi dead
zone. The location you choose must be within the range of your router.
2. Wait for about 2 minutes until the LED turns solid blue. If it doesn't, relocate
the extender closer to the router to achieve better signal quality.
Router Devices
Halfway
Tip: For more intuitive location assistance, access extender settings via the Tether app and go to Tools > Location Assistant.
Blue: Suitable location
Red: Too far from router
Note: If the LED does not turn solid on, try again or use Method 1
or 2.
2. Within 2 minutes, press the WPS button on the
extender for 1 second. The LED should change
from blinking to solid on, indicating successful
connection.
Blinking
Solid On
3. If the extender connects to a dual band router but
only the 2.4GHz or 5GHz LED is on, repeat steps 1
and 2 above to connect to the other band.
Extended Network Names:
Same as your router
Passwords:
Same as your router
Note:
If you want to change the extended network
names, refer to Manage the Extender on the back page.
Solid On
Setup with videos
Scan QR code or visit
https://www.tp-link.com/download/RE455.html
Set up your extender via any of the methods below.
Method 2: Via a Web Browser
1. Connect your computer or smartphone to the
extender’s network. If you are using a computer,
unplug the Ethernet cable if any.
Note: If you can not find the extender’s network, follow FAQ > Q3
to reset the extender.
TP-Link_Extender_2.4GHz
TP-Link_Extender_5GHz
Method 1: Via the Tether App
1. Get the up-to-date Tether app.
2. Connect your smartphone to the extender’s
network.
Note: If you can not find the extender’s network, follow FAQ > Q3
to reset the extender.
TP-Link_Extender_2.4GHz
TP-Link_Extender_5GHz
Scan for Tether Tether
or
To Next Page
Need help?
General
Weight and Dimensions
