Start Here >>
Hello, RE590T
Quick Installation Guide
Note: Make sure to place the extender away from all Bluetooth devices and other household electronics.
Enjoy!
Connect your devices to the extender wirelessly or via an Ethernet cable.
RE590TWireless Wired
Place the extender halfway between your wireless router (Host Network) and the Wi-Fi dead zone.
Note:
1. Both extended networks share the same Wi-Fi password as your host network, but may have
dierent wireless network names if you customize the names during the conguration.
2. To congure the extender using a web browser or WPS, please refer to FAQ > Q1.
2
1
Install the antennas and position
them vertically.
1 Install
2 Power on
Plug the extender’s adapter into an electrical outlet near
your router. Then turn on the extender and wait until the
system boot on the screen completes.
4 Relocate
Ideal Extender Placement
3 Configure
Create a new administrator password (recommended) and tap Save.
1
2
Select your router's 2.4GHz wireless network and enter its password, and
then tap Next.
3
Select your router's 5GHz wireless network and enter its password, and
then tap Next.
Note: If your router does not support the 5GHz band, tap Skip.
4
Either keep the default SSIDs or customize them for both 2.4GHz and
5GHz extended networks, and then tap Next.
Note: Please swipe up for the 5GHz settings.
5
Verify your wireless settings and tap Finish. Corresponding Wi-Fi signal
icon(s) ( 2.4GHz/ 5GHz) at the top left of the touch screen should
be lit.
Make sure the extender receives a strong signal (recommended signal strength or ) from your wireless router. If
not, relocate it closer to the router.
Extended NetworkHost Network
To Next Page
Need help?
General
