Need help?Do you have a question about the TP-Link T1600G-18TS and is the answer not in the manual?
General| Switching Capacity | 36 Gbps |
|---|---|
| Forwarding Rate | 26.78 Mpps |
| MAC Address Table | 8K |
| Fan Quantity | Fanless |
| Power Supply | 100-240VAC, 50/60Hz |
| Mounting | Rack Mountable |
| Jumbo Frame | 9KB |
| Packet Buffer Memory | 1.5MB |
| Ports | 16 x 10/100/1000Mbps RJ45 ports, 2 x 1G SFP slots |
| Standards and Protocols | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.1Q |
| Dimensions | 440 x 180 x 44 mm |
| Operating Temperature | 0°C to 40°C (32°F to 104°F) |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Operating Humidity | 10% to 90% (Non-condensing) |
| Storage Humidity | 5% to 90% (Non-condensing) |
| VLAN Support | 4K VLANs, Port-based VLAN, IEEE 802.1Q VLAN |
| Quality of Service | 8 queues per port, IEEE 802.1p, DSCP |
| Access Control List | L2/L3/L4 ACL |
Explains how to access the switch's web interface for management.
Details methods for accessing the switch via console, Telnet, or SSH.
Covers system information, user management, system tools, and access security.
Explains how to create admin accounts and other user types via GUI and CLI.
Details configurations for boot file, configuration restore, firmware upgrade, and reboot.
Covers configurations for access control, HTTP, HTTPS, SSH, and Telnet.
Details how to set basic parameters for ports using GUI and CLI, including Jumbo frames and flow control.
Covers configuring port security to limit MAC addresses per port using GUI and CLI.
Details on completing LAG configuration, including global load-balancing and static LAG/LACP setup.
Explains how to monitor traffic using Traffic Summary and Traffic Statistics in Detail via GUI and CLI.
Covers adding static MAC entries, modifying aging time, adding filtering entries, and viewing table entries.
Details configuring MAC notification traps and limiting MAC addresses in VLANs.
Details configuring PVID of the port and creating VLANs using GUI and CLI.
Details configuring 802.1Q VLAN, binding MAC to VLAN, and enabling MAC VLAN for ports.
Details configuring 802.1Q VLAN, creating protocol templates, and configuring Protocol VLAN.
Overview of STP, RSTP, and MSTP protocols for preventing network loops.
Details STP/RSTP configurations on ports and globally using GUI and CLI.
Covers MSTP configurations on ports, region, globally, and verification using GUI and CLI.
Explains STP security features like Loop Protect, Root Protect, BPDU Protect, and BPDU Filter.
Details IGMP Snooping configurations globally, on ports, and in VLANs using GUI and CLI.
Explains MLD Snooping configurations globally, on ports, in VLANs, and examples using GUI and CLI.
Details configuring IPv4 and IPv6 parameters for interfaces using GUI and CLI.
Details IPv4 static route configuration using GUI and CLI.
Details IPv6 static route configuration using GUI and CLI.
To Next Page