How to perform a Ping test on TP-Link JetStream T1500-28PCT?
To perform a Ping test on your TP-Link Switch, navigate to MAINTENANCE > Network Diagnostics > Ping. In the Ping Config section, enter the destination device's IP address, and configure the Ping times, data size, and interval as needed. Click Ping to initiate the test. The results will be displayed in the Ping Result section.
How to perform a Tracert test on TP-Link Switch?
To perform a Tracert test on your TP-Link Switch, go to MAINTENANCE > Network Diagnostics > Tracert. In the Tracert Config section, enter the destination IP address and set the maximum hop count. Then, click Tracert to begin the test.
General| PoE Ports | 24 |
|---|---|
| Total PoE Power Budget | 192W |
| Switching Capacity | 56 Gbps |
| Layer | Layer 2 |
| MAC Address Table | 8K |
| Operating Humidity | 10% to 90% non-condensing |
| Storage Humidity | 5% to 90% non-condensing |
| Dimensions | 440 x 180 x 44 mm (17.3 x 7.1 x 1.7 in) |
| Standards and Protocols | IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3af, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p |
| Jumbo Frame | 9K |
| Power Supply | Internal |
| Operating Temperature | 0°C to 40°C (32°F to 104°F) |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Forwarding Rate | 41.66 Mpps |
Access the switch’s web interface through the web-based authentication using HTTP or HTTPS server.
Access the switch via Console, Telnet, or SSH connection to manage the switch with command lines.
View the system information and configure the system parameters and features of the switch.
View system summary, configure device description, system time, daylight saving time, and system IP/IPv6.
Configure port status, speed mode, duplex mode, flow control, and other basic parameters for ports.
Aggregate multiple physical ports into a logical interface for increased bandwidth and reliability.
Configure the global load-balancing algorithm and configure Static LAG or LACP.
Contains address information used to forward packets, mapping MAC addresses, VLAN IDs, and ports.
Add static MAC entries, change aging time, add filtering entries, and view address table entries.
Configure the VLAN, including creating a VLAN and adding ports.
Enable IGMP Snooping globally, for VLANs, and for ports.
STP is a layer 2 Protocol that prevents loops. RSTP and MSTP provide faster convergence and load balancing.
Configure STP/RSTP parameters on ports and globally.
DHCP is used to automatically assign IP addresses and other network configuration parameters.
Process and forward DHCP packets between different subnets or VLANs.
Classify and prioritize network traffic to provide differentiated services to certain types of traffic.
Configure port priority, 802.1p priority, DSCP priority, and specify scheduler settings.
Control traffic rate and threshold on each port to ensure network performance.
Provides security measures for accessing the switch remotely to enhance configuration management security.
Configure Access Control, HTTP, HTTPS, SSH, and Telnet functions.
Configure servers, server groups, method lists, application lists, and login accounts.
Configure RADIUS server, 802.1x globally, and on ports.
Configure port security parameters: max learned MAC, learn mode, and status.
ACL filters traffic by permitting or denying packets based on rules crossing specified interfaces or VLANs.
Configure time range, create ACL, define rules, and bind ACL to port or VLAN.
To Next Page
