How to perform a Ping test on TP-Link JetStream TL-SG2210P?
To perform a Ping test on your TP-Link Switch, navigate to MAINTENANCE > Network Diagnostics > Ping. In the Ping Config section, enter the destination device's IP address, and configure the Ping times, data size, and interval as needed. Click Ping to initiate the test. The results will be displayed in the Ping Result section.
How to perform a Tracert test on TP-Link Switch?
To perform a Tracert test on your TP-Link Switch, go to MAINTENANCE > Network Diagnostics > Tracert. In the Tracert Config section, enter the destination IP address and set the maximum hop count. Then, click Tracert to begin the test.
General| PoE Ports | 8 |
|---|---|
| PoE Budget | 62 W |
| Switching Capacity | 20 Gbps |
| MAC Address Table | 8K |
| Packet Forwarding Rate | 14.88 Mpps |
| Jumbo Frame | 9KB |
| Operating Temperature | 0°C to 40°C (32°F to 104°F) |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Ports | 8× Gigabit PoE+ Ports |
| VLANs | 4K |
| QoS | 4 queues per port |
| Management | Web, CLI, SNMP |
| Standards and Protocols | IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at |
| Operating Humidity | 10% to 90% RH non-condensing |
| Storage Humidity | 5% to 90% RH non-condensing |
Details on how to access the switch via its web interface using HTTP/HTTPS.
Details on configuring VLANs, including creating VLANs and assigning ports.
Guides on enabling IGMP Snooping globally, for VLANs, and for ports to manage multicast traffic.
Guides on enabling DHCP Relay, configuring Option 82, and specifying DHCP server for VLANs.
Details on configuring port priority, 802.1p priority, DSCP priority, and scheduler settings.
Covers configuring rate limits for ingress/egress traffic and storm control.
Guides on configuring OUI addresses, Voice VLAN globally, and adding ports to Voice VLAN.
Explains how to enable Auto VoIP globally and configure ports with DSCP values and CoS override.
Covers configuring Access Control, HTTP, HTTPS, SSH, and Telnet features for secure access.
Details adding servers, configuring server groups, method lists, application lists, and login accounts.
Guides on configuring RADIUS server, 802.1x globally, and on ports for network access control.
Covers configuring the maximum number of MAC addresses per port and actions upon exceeding the limit.
Details on creating MAC ACL, IP ACL, Combined ACL, IPv6 ACL, and configuring rules and policies.
Explains manual binding, ARP scanning, and DHCP snooping for IP-MAC entries.
Guides on enabling ARP Detection globally, for VLANs, and on ports to prevent ARP attacks.
Covers configuring IPv4 Source Guard to filter IPv4 packets based on IP-MAC binding table.
Explains manual binding, ND Snooping, and DHCPv6 Snooping for IPv6-MAC entries.
Guides on enabling ND Detection globally, for VLANs, and on ports to prevent ND attacks.
To Next Page