Configuring GVRP GVRP Configuration
User Guide 197
2.1 Using the GUI
Choose the menu L2 FEATURES > VLAN > GVRP > GVRP Config to load the following
page.
Figure 2-1 GVRP Config
Follow these steps to configure GVRP:
1) In the GVRP section, enable GVRP globally, then click Apply.
2) In the Port Config section, select one or more ports, set the status as Enable and
configure the related parameters according to your needs.
Port Select the desired port for GVRP configuration. It is multi-optional.
Status Enable or disable GVRP on the port. By default, it is disabled.
Registration
Mode
Select the GVRP registration mode for the port.
Normal: In this mode, the port can dynamically register and deregister VLANs,
and transmit both dynamic and static VLAN registration information.
Fixed: In this mode, the port is unable to dynamically register and deregister
VLANs, and can transmit only the static VLAN registration information.
Forbidden: In this mode, the port is unable to dynamically register and deregister
VLANs, and can transmit only information of VLAN 1.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
