How to perform a Ping test on TP-Link Jetstream TL-SL2428P Switch?
To perform a Ping test on your TP-Link Switch, navigate to MAINTENANCE > Network Diagnostics > Ping. In the Ping Config section, enter the destination device's IP address, and configure the Ping times, data size, and interval as needed. Click Ping to initiate the test. The results will be displayed in the Ping Result section.
How to perform a Tracert test on TP-Link Jetstream TL-SL2428P?
To perform a Tracert test on your TP-Link Switch, go to MAINTENANCE > Network Diagnostics > Tracert. In the Tracert Config section, enter the destination IP address and set the maximum hop count. Then, click Tracert to begin the test.
General| PoE Ports | 24 |
|---|---|
| PoE+ | Yes |
| Switching Capacity | 56 Gbps |
| MAC Address Table | 16K |
| Power Supply | Internal |
| Input Voltage | 100-240VAC, 50/60Hz |
| Weight | 3.8 kg |
| Operating Humidity | 10% to 90% non-condensing |
| Certifications | CE, FCC, RoHS |
| Product Type | Managed Switch |
| Dimensions (W x D x H) | 440 x 44 mm |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
| Standards and Protocols | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1p, IEEE 802.1Q |
| Forwarding Rate | 41.67Mpps |
| Jumbo Frame | Yes, up to 9216 bytes |
To Next Page
