User Guide 670
Configuring IPv6 IMPB IPv6-MAC Binding Configuration
Follow these steps to configure IPv6-MAC Binding via DHCPv6 Snooping:
1) In the Global Config section, globally enable DHCPv6 Snooping. Click Apply.
2) In the VLAN Config section, enable DHCPv6 Snooping on a VLAN or range of VLANs.
Click Apply.
VLAN ID Displays the VLAN ID.
Status Enable or disable DHCPv6 Snooping on the VLAN.
3) In the Port Config section, configure the maximum number of binding entries a port can
learn via DHCPv6 snooping. Click Apply.
Port Displays the port number.
Maximum Entries Configure the maximum number of binding entries a port can learn via DHCPv6
snooping.
LAG Displays the LAG that the port is in.
4) The learned entries will be displayed in the Binding Table. You can go to SECURITY >
IPv6 IMPB > IPv6-MAC Binding > Binding Table to view or edit the entries.
2.1.4 Viewing the Binding Entries
In the Binding Table, you can view, search and edit the specified binding entries.
Choose the menu SECURITY > IPv6 IMPB > IPv6-MAC Binding > Binding Table to load the
following page.
Figure 2-4 Binding Table
You can specify the search criteria to search your desired entries.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
