TP-Link Jetstream TL-SL2428P - Using the CLI

User Guide 687
Configuring IPv6 IMPB Configuration Examples
Figure 5-5 Port Config
5) Click to save the settings.
5.1.4 Using the CLI
1) Manually bind the entries for User 1 and User 2.
Switch_A#configure
Switch_A(config)#ipv6 source binding User1 2001::5 74:d3:45:32:b6:8d vlan 1 interface
fastEthernet 1/0/1 nd-detection
Switch_A(config)#ip source binding User1 2001::6 88:a9:d4:54:fd:c3 vlan 1 interface
fastEthernet 1/0/2 nd-detection
2) Enable ND Detection globally and on VLAN 1.
Switch_A(config)#ipv6 nd detection vlan 1
3) Configure port 1/0/3 as trusted port.
Switch_A(config)#interface fastEthernet 1/0/3
Switch_A(config-if)#ipv6 nd detection trust
Switch_A(config-if)#end
Switch_A#copy running-config startup-config
Verify the Configuration
Verify the IPv6-MAC Binding entries:
Switch_A#show ipv6 source binding
Downloaded from ManualsNet.com search engine