User Guide 30
Managing System System Info Configurations
2.1.6 Configuring the System IP
Choose the menu SYSTEM > System Info > System IP to load the following page.
Figure 2-9 Configuring the Sysrtem IP Parameters
Follow these steps to configure the System IP:
1) Configure the corresponding parameters for the system IP
Management
VLAN ID
Specify the management VLAN of the switch. Only the computers in the
management VLAN can access the management interface of the switch. By
default, VLAN 1 owning all the ports is the management VLAN and you can
access the switch via any port
.
IP Address Mode Specify the IP address assignment mode of the interface.
Static: Assign an IP address to the management interface.
DHCP: Assign an IP address to the management interface through the DHCP
server.
BOOTP: Assign an IP address to the management interface through the BOOTP
server.
DHCP Option 12 If you select the IP Address Mode as DHCP, configure the Option 12 here.
DHCP Option 12 is used to specify the client’s name.
IP Address Specify the IP address of the management interface if you select the IP Address
Mode as Static.
Subnet Mask Specify the subnet mask of the management interface if you select the IP
Address Mode as Static.
Default Gateway Specify the default gateway of the management interface if you select the IP
Address Mode as Static. The default gateway is the IP address to which the
packet should be sent next.
2) Click Apply.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
