TP-Link Jetstream TL-SL2428P - Viewing ARP Statistics

User Guide 648
Configuring IPv4 IMPB ARP Detection Configuration
Switch(config-if)#ip arp inspection burst-interval 2
Switch(config-if)#show ip arp inspection interface gigabitEthernet 1/0/2
Interface Trust state limit Rate(pps) Current speed(pps) Burst Interval Status LAG
--------- ----------- --------------- ------------------ -------------- -------- ---
Gi1/0/2 Enable 20 0 2 --- N/A
Switch(config-if)#end
Switch#copy running-config startup-config
The following example shows how to restore the port 1/0/1 that is in Down status to Normal
status:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#ip arp inspection recover
Switch(config-if)#end
Switch#copy running-config startup-config
3.2.4 Viewing ARP Statistics
On privileged EXEC mode or any other configuration mode, you can use the following
command to view ARP statistics:
show ip arp inspection statistics
View the ARP statistics on each port, including the number of forwarded ARP packets and the number of
dropped ARP packets.
Downloaded from ManualsNet.com search engine