Configuring QoS Bandwidth Control Configuration
User Guide 459
3
Bandwidth Control Configuration
With bandwidth control configurations, you can:
■ Configure rate limit
■ Configure storm control
3.1 Using the GUI
3.1.1 Configuring Rate Limit
Choose the menu QoS > Bandwidth Control > Rate Limit to load the following page.
Figure 3-1 Configuring Rate Limit
Follow these steps to configure the Rate Limit function:
1) Select the desired port and configure the upper rate limit to receive and send packets.
Ingress Rate (0-
1,000,000Kbps)
Configure the upper rate limit for receiving packets on the port. The valid values
are from 0 to 1000000 Kbps and 0 means the ingress rate limit is disabled.
Egress Rate (0-
1,000,000Kbps)
Configure the bandwidth for sending packets on the port. The valid values are
from 0 to 1000000 Kbps and 0 means the egress rate limit is disabled.
2) Click Apply.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
