Configuring LLDP LLDP Configurations
User Guide 363
2.1.2 Configuring LLDP For the Port
Choose th menu L2 FEATURES > LLDP > LLDP Config > Port Config to load the following
page.
Figure 2-2 Port Config
Follow these steps to configure the LLDP feature for the interface.
1) Select one or more ports to configure.
2) Configure the Admin Status and Notification Mode for the port.
Admin Status Set Admin Status for the port to deal with LLDP packets.
Tx&Rx: The port transmits LLDP packets and receives LLDP packets.
Rx_Only: The port only receives LLDP packets.
Tx_Only: The port only transmits LLDP packets.
Disable: The port will not transmit LLDP packets or drop the received LLDP
packets.
Notification
Mode
(Optional) Enable the switch to send trap messages to the NMS when the
information of the neighbor device connected to this port changes.
Management
Address
Specify the Management IP address of the port to be notified to the neighbor.
Value 0.0.0.0 means the port will notify its default management address to the
neighbor.
3) Select the TLVs (Type/Length/Value) included in the LLDP packets according to your
needs.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
