TP-Link Jetstream TL-SL2428P - Specifying the Scheduler Settings

User Guide 456
Configuring QoS Class of Service Configuration
DSCP remap value 8 5 10 11 12 13 14 15
---- ---- ---- ---- ---- ---- ---- ----
DSCP: 16 17 18 19 20 21 22 23
DSCP remap value 16 17 18 19 20 21 22 23
---- ---- ---- ---- ---- ---- ---- ----
DSCP: 24 25 26 27 28 29 30 31
DSCP remap value 24 25 26 27 28 29 30 31
---- ---- ---- ---- ---- ---- ---- ----
DSCP: 32 33 34 35 36 37 38 39
DSCP remap value 32 33 34 35 36 37 38 39
---- ---- ---- ---- ---- ---- ---- ----
DSCP: 40 41 42 43 44 45 46 47
DSCP remap value 40 41 42 43 44 45 46 47
---- ---- ---- ---- ---- ---- ---- ----
DSCP: 48 49 50 51 52 53 54 55
DSCP remap value 48 49 50 51 52 53 54 55
---- ---- ---- ---- ---- ---- ---- ----
DSCP: 56 57 58 59 60 61 62 63
DSCP remap value 56 57 58 59 60 61 62 63
---- ---- ---- ---- ---- ---- ---- ----
Switch(config-if)#end
Switch#copy running-config startup-config
2.2.4 Specifying the Scheduler Settings
Follow these steps to specify the scheduler settings to control the forwarding sequence of
different TC queues when congestion occurs.
Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list |
port-channel port-channel-id | range port-channel port-channel-list }
Enter interface configuration mode.
Downloaded from ManualsNet.com search engine