User Guide 685
Configuring IPv6 IMPB Configuration Examples
3) Configure ND Detection on ports. Since port 1/0/3 is connected to the gateway router,
set port 1/0/3 as trusted port.
Demonstrated with T1500-28PCT, the following sections provide configuration procedure
in two ways: using the GUI and using the CLI.
5.1.3 Using the GUI
1) Choose the menu SECURITY > IPv6 IMBP > IPv6-MAC Binding > Manual Binding
and click to load the following page. Enter the host name, IPv6 address, MAC
address and VLAN ID of User 1, select the protect type as ND Detection, and select port
1/0/1 on the panel. Click Apply.
Figure 5-2 Binding Entry for User 1
2) In the same way, add a binding entry for User 2. Enter the host name, IPv6 address, MAC
address and VLAN ID of User 2, select the protect type as ND Detection, and select port
1/0/2 on the panel. Click Apply.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
